January 24, 2022 (Chandler, AZ) – Rogers Corporation (NYSE:ROG) will be launching its Radix™ 3D Printable Dielectrics family of products at the IPC APEX EXPO 2022, January 25th through January 27st, at the San Diego Convention Center in San Diego, CA. The IPC APEX EXPO (www.ipcapexexpo.org) is the leading event for the printed circuit board and electronics manufacturing and assembly industry, providing a full technical conference along with the exhibitor expo.
Visitors to booth 3433 will be able to learn more about the Radix™ 3D Printable Dielectrics family of products, with the first available material featuring a dielectric constant of 2.8 and low loss characteristics at microwave frequencies. These printable dielectric materials give radio frequency (RF) designers unprecedented design freedom in creating new components, eliminating the need to consider typical manufacturing design constraints.
Rogers Corporation’s Radix 3D Printable Dielectrics are proprietary composite materials designed for Digital Light Processing (DLP) 3D printing, enabling a scalable, high-resolution printing process for end-use RF dielectric component manufacturing. Rogers Corporation’s first Radix 3D Printable Dielectric material has a targeted dielectric constant of 2.8 and a dissipation factor of 0.0043 at 10 GHz when cured.
The new materials are intended for use as RF materials in applications where new geometric freedom can enhance the figure of merits of an RF system, such as gradient dielectric constant (GRIN) structures and other complex three-dimensional parts. The Radix 3D Printable Dielectrics offer the industry a way to manufacture systems and components at scale that could not be made with traditional fabrication methods. Radix materials are available directly from Rogers Corporation and our 3D printing partners.
Learn more about Radix 3D Printable Dielectrics: